- 75 months ago
Hey all. This is my setup.
The two SSDs are new, and I wanted to set them up with RAID 0 (to essentially have a single 500GB drive.) My motherboard has a guide (warning: large PDF file) for setting up RAID, but it doesn't seem to be working out. I'm following Section 1.3.1 / Way 2.
I swapped my drive mode over to "RAID" from "IDE" (what I was previously using for my 1TB drive -- had issues with AHCI with it for some reason), then I booted into the EFI shell, ran "drvcfg".
Looking at the guide, they get an output like this:
Configurable Components Drv Ctrl[DE] Lang[en]
My output looked like this:
The next step in the manual is "When the following screen appears, enter "dh [Drv number]" and click [Enter]." On their screen, after the output of "Drv Ctrl[DE] Lang[en]" they type the following:
Shell> dh 4E
I have no clue where they got "4E" from. And my "drvcfg" isn't returning the information it should be. Could anyone lend me a hand? I would really appreciate it.